KDB06EW-TLxx | ปลั๊กคอนเนคเตอร์

Introduction
The KDB circular Bayonet coupling connector series was designed in accordance with VG95234 specification. This highly reliable connector series is an improvement on the well established MIL-DTL-5015 type.

The KDB series has a proven bayonet coupling design that offers exceptional vibration protected sealing against fluid, and easy connection/disconnection. This KDB series designed standard connector for application in ground fighting equipments.

Connectors in accordance with VG95234 are interchangeable with the corresponding MIL-DTL-5015 connectors. Both connector lines feature the same shell dimensions and contacts layouts. However, due to the different coupling systems(MIL-DTL-5015 threaded coupling, VG95234 bayonet coupling) they are not intermateable.

Advantages
- Rugged shell design
- Environmental
- Bayonet coupling for easy mating and unmating
- Vibration proof
- Waterproof up to 1 bar (35 feet of water)

Connector design
Due to the very rugged shell designs in aluminium alloy, this connector complies with the heavy duty and environmental requirements of military equipment. They also withstand abuse during servicing.

The olive drab chromate and cadmium plated finish protects the shell against environmental influences.

Insulators, grommets and 0-rings are made of high quality polychloroprene and withstand temperatures from-55 "C to 125"C. In addition, they are resistant against hydraulic fluids, jet fuel, diesel fuel, gasolines,lubricants and fire extinguisher fluids, and also meet the requirements of UL-95 self extinguishing.

The contacts, made of copper alloy plated with a hard silver finish guarantee at least 500 mating cycles.

All solder contacts are pretinned and enable fast and high quality soldering. The crimp contacts allow highly reliable crimping with wires according to TL6145-009, TL6145-011 and MIL-W-5086 when using the recommended tools according to VG95234. All crimp contacts can be exchanged at least five times due to the contact retention.

The bayonet design allows very fast and easy coupling and uncoupling. After a 120·tum of the coupling nut, the roller bolt snaps-in into the locking position of the bayonet groove with a metallic sound. In addition to this audible snap-in, the locked position is marked by colored arrows.

KDB connectors are basically designed for single wire harnessing. Under certain conditions, jacketed cables can be used for the shell styles E, G, M and N.

For full environmental sealing each conductor is sealed completely within the special sealing grommet.